Fluke Corporation                                           MET/CAL Procedure
=============================================================================
INSTRUMENT:            Fluke 76: CAL ADJ /5500
DATE:                  17-Oct-96
AUTHOR:                Fluke Corporation
REVISION:              $Revision: 1.2 $
ADJUSTMENT THRESHOLD:  70%
NUMBER OF TESTS:       1
NUMBER OF LINES:       61
CONFIGURATION:         Fluke 5500A
=============================================================================
#
# Source:
#   Fluke 76 True RMS Multimeter Service Manual (PN 103926 October 1995)
#
# Compatibility:
#   5500/CAL 4.0 or MET/CAL 4.0 or later
#
# Subprocedures:
#   None
#
# Required Files:
#   None
#
# System Specifications:
#   TUR calculation is based on specification interval of the accuracy file.
#   The default 5500A accuracy file contains 90 day specs.
#
# Fluke makes no warranty, expressed or implied, as to the fitness
# or suitability of this procedure in the customer's application.
#
# The 90 day specifications of the 5500A are used in TUR computations.
#
 STEP    FSC    RANGE NOMINAL        TOLERANCE     MOD1        MOD2  3  4 CON
  1.001  ASK-                          J                          F        W
  1.002  HEAD         PRELIMINARY INSTRUCTIONS
  1.003  DISP         Warm-up time: NONE
  1.003  DISP         Temperature : 18 - 28 degC
  1.003  DISP         Humidity    : <80%
  1.004  DISP         [32]                WARNING
  1.004  DISP         HIGH VOLTAGE is used or exposed during the performance
  1.004  DISP         of this calibration.  DEATH ON CONTACT may result if
  1.004  DISP         personnel fail to observe safety precautions.
  1.005  DISP         Disconnect the test leads if attached. Remove the four
  1.005  DISP         phillips-head screws from the bottom of the case. Turn
  1.005  DISP         the instrument face-up, and grasp the top cover at both
  1.005  DISP         sides of the input connectors. Then, pull the top cover
  1.005  DISP         from the UUT.
  1.006  HEAD         DC VOLTAGE CALIBRATION
  1.007  DISP         Select the V DC function on the UUT.
  1.008  DISP         Connect the 5500A to the UUT as follows:
  1.008  DISP         [32] 5500A NORMAL HI to UUT V Ohm Diode
  1.008  DISP         [32] 5500A NORMAL LO to UUT COM
  1.009  5500         3.5V                                              S  2W
  1.010  DISP         Adjust R21 for a UUT reading of 3.500 +/- 0.001V.
  1.011  5500         *                                                 S
  1.012  HEAD         AC VOLTAGE CALIBRATION
  1.013  DISP         Select the V AC function on the UUT.
  1.014  5500         3.5V                         100H           SI    S  2W
  1.015  DISP         Adjust R34 for a UUT reading of 3.500 +/- 0.002V.
  1.016  END